Plumbing system has been very important in our daily lives primarily because it helps a lot in the maintenance of organized system of wastes as well as proper hygiene. Given these facts, one should at least take care of this plumbing system to avoid interruptions in daily household chores. In this article, a particular plumbing related object will be discussed which is the tub spout.
Replacing the tub spout is easy and can be done on your own. All you need is to read the manufacturer’s manual for a better way of installing it. Below are the steps in replacing the tub spout.
-
Remove the tub spout by turning it counterclockwise. But before doing it, you should be able to unscrew all bolts in it. If you are having a difficult time doing it, you may use some tools like the wrench.
-
Remove the sharp edges or burrs in the end of Tubing with sandpaper until smooth.
-
Slide the adapter into the stub out nipple then put some grease as a lubricant.
-
Slide the O-ring into the stub out nipple.
-
Slide extension nipple into the stub out nipple and tie it into the adapter. The adapter should be aligned with the extension nipple. To do this, tighten extension nipple into the adapter until the adapter aligns with the extension nipple’s holes.
-
Tie the screw in the retainer ring then let the retainer ring assemble slide into the extension nipple. The screw should also be aligned in the recessed hole in the extension nipple. Tighten the screw just enough to hold the parts in place. Avoid over tightening.
-
Put a pipe thread tape in the male end part of the extension nipple.
-
Tighten the newly installed spout in the extension nipple.
-
You can now test it if it’s properly installed by turning the water on. If there’s no leaks, then it is well installed, otherwise, you should reinstall it. in that case, you might need to call a plumber to help you.
In case you need plumbers in solving the problem, you should call London Plumbers. We are happy to serve you!
Recent Comments